Cummins Diesel Forum banner

Running lights but no headlights?

11K views 9 replies 6 participants last post by  meanmachine1978  
#1 ·
Had a battery bite the dust last night. Replaced it this morning and now my headlights wont work. Running lights and tail lights work. When i flip to turn on my brights i get no high beam light in the truck.

Did i blow a fuse?

Did the wiring harness go bad?


Help me out if you can!!!! I dont want to have to bum a ride to work again.
 
#5 ·
thanks. that was my next part i was going to check out. also could the wiring harness be bad? they worked fine the other day and now no headlights but still have running lights and tail lights. They actually seemed brighter with the new fuse.
 
#7 ·
Its more than likely the switch. Last week I was plowing non stop for a few days and shut the truck off turned of the lights and started using the snowblower, went to leave 2hrs later and I had running lights and no headlights, long story short put in a new switch and I was good to go
 
#8 ·
I am having the same problem now. Everything worked fine the other day and then I washed my truck(didnt wash under hood) and when I left I had no headlights. Parking lights and fog lights work but no headlights. I checked fuses and everything was fine, replaced the switch on the dash and still nothing. The wires on the back in the harness seem to be fine. Could use some help guys.
 
#10 ·
Used a tester and checked both fuse boxes. Pulled my bulbs and both were blown. Replaced them and everything works fine now but something caused them to blow. Thinking I have a bare wire somewhere and when I washed my truck it got wet and bam, no lights. Now I just need to spend the time to find the real problem.