đź‘‹ Welcome to the Cummins Diesel Forum
2019+ 4.5 Gen Ram 6.7 Cummins
2019+ “5th” Gen
2013-2018 4th Gen Ram 6.7L Cummins
Late 4th Gen Trucks- All with DEF
2010-2012 4th Gen Ram 6.7L Cummins
Early 4th Gen Trucks- Non DEF Pickups
2007.5-2009 3rd Gen Dodge 6.7L Cummins
DPF Equipped 6.7s
2003-2007.0 3rd Gen Dodge 5.9L Cummins
The High Pressure Common Rail 5.9s
1998.5-2002 2nd Gen Dodge 5.9L 24V Cummins
The VP44 5.9s
1994-1998.0 2nd Gen Dodge 5.9L 12V Cummins
The P7100 5.9s
1989-1993 1st Gen Dodge 5.9L 12V Cummins
VE pump 5.9s
Other Non-Dodge/Ram Cummins Applications
If your Cummins is in an HD truck, RV, Boat, etc, then this is your section!
Conversions - ShopTalk - Tools&Boxes - Fabrication
NO ADVERTISING
Discussion of the Cummins Conversions and Fabrication Needed to Complete. Talk about and show off your Tools - Tool Boxes & Shops. Show off your General Fabrication Projects
General Forums
Specialty Forums
Technical Articles - Writeups - Guides Section
Forum Resources
Marketplace
Member for at least 10 days with a minimum of 20 posts required to access
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Regional Forums
Forum Support
Community Hall
Latest Posts
-
I have an early year 2006 Mega Cab Laramie (dual zone) truck. Had a sudden AC failure diagnosed by the shop as a compressor failure. It has around 186k miles, which is similar to when my 2005 compressor failed. The short version is do I keep using the old evaporator after a flush or try to...
-
Yes, it is a 2003 with only 33,500 miles when this issued began. I will repeat this again to prevent any sarcastic comments. Yes, A. that is the correct miles on vehicle and engine. and B. Since brand new there have been no mods or Rub Goldberg mods such as chipping, filter mods, injector...
-
1998 dodge 2500 dana 60 I have a spicer greaseable u joint and xrf ball joints. First problem I had when putting on ball joints, I used the c clamp ball joints tool and a hammer, making sure not to hit bolt to much. Now my upper ball joint when I have it in the knuckle and torqued to 70 ft lb...