Dodge Cummins Diesel Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
352 Posts
Discussion Starter · #1 ·
What would it take to run low-mid 12s in my truck? it'll have drag radials and traction bars on it. I'll have water/meth also. Would like to have a single turbo that could also be streetable.
 

·
Registered
Joined
·
2,796 Posts
well..for a turbo that would meet your needs i would think a quick diesel 64, youl need the springs, injectors, basically a little of everything:hyper:
 

·
Registered
Joined
·
2,796 Posts
maybe 150s? but for a 64 i would run 200s
 

·
Registered
Joined
·
352 Posts
Discussion Starter · #5 ·
so a 64, some 200's, o-ring, stud, built tranny, 4k gsk, water/meth, 191s and....?
 

·
Registered
Joined
·
2,796 Posts
throw a im no 12 v genious but it all sounds right...pf cpurse there all the fuel plates and the basics but it appears its all been done
 

·
Registered
Joined
·
352 Posts
Discussion Starter · #7 ·
Will i need a output shaft or can i leave it stock since 2wd? seems like i would lose traction before it would break.
 

·
Registered
Joined
·
695 Posts
2wd transmissions dont have an output shaft so u are good there, just an input and intermediate
 

·
Banned
Joined
·
1,747 Posts
get a damn gt4594 off a volvo semi and get a staged boost controller, head studs and some big injectors....you'll run a 12 :p .....I might so that, lol. dunno, what u think?
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top