Cummins Diesel Forum banner

Volant powercore for twins?

696 Views 2 Replies 2 Participants Last post by  North Maine
Most kits just use a generic high-flow (low filtration unless PERFECT) oiled filter. I'd like to run a volant powercore (Filtered by Donaldson- which I like) but I fear that it wont be able to handle the flow rate of the twins and I'll end up starving my HX35/HT3B system. I have searched all over and cant find any CFM/vacuum numbers on the Volant filter and the Donaldson site is too generic to be of much use. :confused013:
1 - 1 of 3 Posts
I would like to do the same.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.