Dodge Cummins Diesel Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
I started feeling a slight-moderate vibration today, so I went and had my tires balanced. There is still a vibration starting out about 45-ish, seems to get progessively worse with speed. Also seems to be worse under acceleration. There doesn't seem to be any slack at all in the u-joints. Any suggestions??
 

· Registered
Joined
·
48 Posts
Discussion Starter · #2 ·
Could this be a tranny problem? Any help will be appreciated......
 

· Registered
Joined
·
189 Posts
My bet is its the u-joint at the rear axle. Sometimes they don't get lose. How many miles?
 

· Registered
Joined
·
111 Posts
could be the ujoint a the axile i just did mine it dident get lose it locked up i thought it was just my carrier barring and found it while working on that
 

· Registered
Joined
·
48 Posts
Discussion Starter · #5 ·
Preciate guys, I have have been doin some more looking and that seems to be the best bet. I'll drop one in 2morrow and post back. It just clicked 59k miles
 

· Registered
Joined
·
551 Posts
What frequency is the vibration.
 

· SNAFU
Joined
·
4,723 Posts
I am guessing U-joint too, be sure to check your front driveline too, it only takes about 10mins to take off and then drive without it on there to see if the vibration is gone. :thumbsup:
 

· Registered
Joined
·
48 Posts
Discussion Starter · #8 ·
Well, replaced the rear u-joint- problem solved. One cap on the u-joint was dry and a little gaulded up. Thanx again:yourock::yourock:
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top