Cummins Diesel Forum banner
Cancel

ve injection troubleshooting

599 Views 3 Replies 4 Participants Last post by  myother4x4isaCJ7, 
C
alright so i have all the injection lines in the correct place now but its not turning over still, picked up a can of ether and its firing off the ether and will run for about 30 seconds but the truck has no throttle response in the short time it will run, thinking about deleting the fss for the time being to see because each injector is getting fuel but not nearly enough. any other ideas on what else could be wrong?
Reply
Save
Like
1 - 1 of 4 Posts
Philip
You need to bleed the injection pump and lines out. Loosen the injection lines at the injectors. Using the starter. Turn the engine over till you see high pressure fluid coming out of the connections. Then tighten the lines. About the third line you tighten up the engine should start.

A second person helps a lot if you don't have a remote starter to use.
Reply
Save
Like
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cummins Diesel Forum
A forum community dedicated to all things Cummins Diesel! Originally founded for owners and enthusiasts of Cummins powered Dodge pickups, the Cummins Forum has expanded to include ALL Cummins Engine applications! Come join the discussion about reviews, drivetrain swaps, turbos, modifications, classifieds, builds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
03-07 Performance Parts Discussion 03-07 Powertrain 2013-2018 General Discussion 98.5-02 Powertrain 98.5-02 Performance Parts Discussion
Top