Dodge Cummins Diesel Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Help!!!!
Transmission went into neutral it seemed under a load and now I have nothing besides a park pin. Only code it threw was for the transfer case switch (P0839). Which after reading everything that switch does I replaced it. Still nothing. Fluid levels are good, not contaminated, and doesn’t seem dirty. Truck starts and runs but doesn’t go in any gear. No noises. Literally was half throttle and it was like someone put it in neutral. Transmission had been “Built” prior to me purchasing the truck three years ago. Never got a build sheet on it was just told that it was done by someone in Cleveland and got a receipt, ($4,189.00). Any ideas to steer me in the right direction would be greatly appreciated.
 

·
Premium Member
Joined
·
15,486 Posts
Pull it and tear it down, not much choice. Could be the TC failed internally, could have broken an input shaft. If the trans is showing full when idling in neutral and you don't see burnt fluid something broke.
 
1 - 2 of 2 Posts
Top