Dodge Cummins Diesel Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 6 of 6 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
im throwing a code for gov. pressure above 3 psi when vehicle speed is 0....transmission is starting to shift goofy...... i think its time for a new one but money is kind of a problem now after spending 2g's in mods.....any one have any ideas of solution.......thanks- mike
 

·
Registered
Joined
·
1,145 Posts
if im thinking correctly, there is a governor pressure reglator in the valve body, its on the passenger side wth a plug in on it, you may want to check that, at the worst i think you may need a new valve body (<$400 i think) im not positive on this though, im sure someone on here will correct me:popcorn:
 

·
Registered
Joined
·
180 Posts
if you change the gov pressure switch you also need to change the transducer switch these need to read the same voltage i picked up both of them at the dealership just over 200 bucks. napa selles them cheaper. after i changed mine it shifted great.
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #5 ·
thanks alog guys....well im getting ready to roll 100k and the truck is parked and in in the process of buying a after market warranty....what have u guys heard about those......36 month 36000 mile warranty for 1700 full coverage
 

·
Registered
Joined
·
540 Posts
Warranty = crap, general matinence which you need to do anyway will make sure you don't have problems. Shops will always try to find a way to get out of anything.
 
1 - 6 of 6 Posts
Top