Dodge Cummins Diesel Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
102 Posts
Discussion Starter · #1 · (Edited)
Ive done a ton of reading and what not and I just need to be told point blank.. Will the XD monsters 20x9 with 18mm offset fit on a stock truck. (With cooper zeon ltz LT275/65R20 34.21x11.27 is the measurements on the tire) . An how far will the 18mm stick out. I had xd revolvers 17x9 with a -12mm offset and loved that offset, just wanna get close to that same look. Filled out the pocket flares nice. Thanks guys.
 

·
Registered
Joined
·
102 Posts
Discussion Starter · #4 ·
BS is 5.71". Im not so much worried about the tire size the 285/75/17s i was runnin were 34.50x11.50 and they didnt rub but a lil at full lock. So i already have pinned the fenders back.
 

·
Registered
Joined
·
102 Posts
Discussion Starter · #8 ·
Thanks for all the input guys! 2011Cummins Do u have shot of ur truck lookin down the side from the front. So I can see how far they stick out? Man I love the single cab short bed that is [email protected]$$!!!!!
 

·
Registered
Joined
·
102 Posts
Discussion Starter · #10 ·
Thanks I really appreciate it!
 

·
Registered
Joined
·
102 Posts
Discussion Starter · #12 ·
Man I searched high an low. My younger bro works as mech. He does a ton of dealin with tires an rims. An between the two of us, 3 ambush was all we could find. So Im gonna settle for the monsters. I got to thinkin what if I find 4 an then screw one up. Id just be SOL! Just cant figure out if I want the 20x9 or 20x10. I want em to stick out a lil. So they will look right with my pocket flares. I always have a hard time makin my mind up.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top