Dodge Cummins Diesel Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Ok i bought a south bend street dual disk a while back and put it in last night. So far I like it alot. But the only problem I have is that it smells hot like it's slipping but it's not. So to put an exact scenario down, once the clutch was installed we took it out for a rip. I know this probably is against the break in cycle but I got excited. Drove probably 20 minutes or so no slipping at all and I didn't notice any smells of a hot clutch. After the 20 minutes or so I did a 3rd gear boost launch at about 20 psi and it held great. When we got back to the shop the clutch smelled as if it had been slipping which is understandable given that I had forced it to slip just before that. A few hours later I drove it home being easy on it and it still smells hot. I just don't really see how it would still be hot from 2 hours prior. Other than that I'm very satisfied!
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #6 ·
Well I'm not a totall . I know that if it sits the bed it's my fault. I wouldn't try to warranty that. But thanks.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #7 ·
And yes I made sure that everything was very clean and installed properly. It seems to be just fine now. Thanks for the input cumminsrulez
 
1 - 4 of 4 Posts
Top