Dodge Cummins Diesel Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 10 of 10 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
Well it took a while, but after I finally got it downloaded and loaded into the truck what a difference. I was running Sw#7 on a 4.06 version that came with the smarty and I haven't been on a dyno but Sw#1 with torque on #3 seems to feel the same. Only difference is it is way smoother power. Way to go Bob and Marco.:woot::thumbsup When I was loading up my computer I downloaded everything first and then plugged my smarty in for the first time, I didn't get anything on the screen that recognized the programmer but it loaded up the program. Is this normal??? Or did I do something wrong. Thanx for the info...:peelout
 

·
Tech Specialist
Joined
·
1,316 Posts
I had to tell it where the drivers were. after that open up the USB loading program and all is good.
 

·
Registered
Joined
·
110 Posts
I finally got the TNT uploaded on my smarty last night too.. it took almost 30 minutes to figure everything out but boy it was worth it.. the power and throttle response in nuts :hyper:
 

·
Registered
Joined
·
96 Posts
the site said the tnt wasnt really designed for basically stock trucks, i dont really have anything special done to mine, just air filter and exhaust, should i stay away from the tnt? i have been running my smarty on 5 for the last couple months...i do have a heavier valair clutch as well.
 

·
Registered
Joined
·
23 Posts
Discussion Starter #6
Awesome program. Lots of power and very smooth. It's like anything though, common sense goes a long ways when you play with mods. Just my.02....
 

·
Registered
Joined
·
364 Posts
I think Smarty needs to open up a tranny repair shop! :lol3:
 

·
Registered
Joined
·
1,119 Posts
I think we need a seperate discussion area just for Smarty talk, thats about 80% of whats in the 3rd gen performance forum. Just a thought...
 
1 - 10 of 10 Posts
Top