Dodge Cummins Diesel Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 13 of 13 Posts

·
Registered
Joined
·
236 Posts
Discussion Starter #1
I have recently purchased my Smarty tuner and was going to download a new program but I didn't receive a USB cord with it. How do I go about downloading a new program without the cord?
 

·
Registered
Joined
·
236 Posts
Discussion Starter #4
use a usb printer cord...its the same thing.
This was the kind of answer I was looking for. I wasn't sure if any other cord would suffice or if I needed to get one particuliarly for the Smarty.
 

·
Tech Specialist
Joined
·
1,316 Posts
nope, just a USB-A to a USB-B cable, and about 40 min to load the software onto the smarty from the computer.
 

·
Registered
Joined
·
236 Posts
Discussion Starter #6
Well I have figured out the cord situation but I am apparently retarted about downloading and installing the right programs or procedure for uploading new programs. Any help would be appreciated, from the start.
 

·
Registered
Joined
·
1,526 Posts
nope, just a USB-A to a USB-B cable, and about 40 min to load the software onto the smarty from the computer.
actually only 25 minutes now :woot:

Well I have figured out the cord situation but I am apparently retarted about downloading and installing the right programs or procedure for uploading new programs. Any help would be appreciated, from the start.
Have you read this yet?

http://www.madselectronics.com/downloadfiles/USBDriverinstallation.pdf
 

·
Tech Specialist
Joined
·
1,316 Posts
I just noticed that. . .I loaded the TNT tune onto my smarty and noticed it only took 25 min
 

·
Registered
Joined
·
163 Posts
Mine only took about 20 and it made a big difference with the revo/tnt. I stack with the 6 Gun and my mileage went up about three mpg and I'm running the TNT on 8 and the Banks on 2 :peelout
 

·
Registered
Joined
·
236 Posts
Discussion Starter #11
Well I am still trying to figure out how to get the Revo...
 

·
Tech Specialist
Joined
·
1,316 Posts
first you need to install the USB driver for your computer. then useing the same cable you would use for a USB printer, connect the smarty up and it will power up. after your computer has finnished loading the proper drivers open the Downloader to load the new software. Once the downlaoder window pops up click file and tell it what program you want to load, then click send. 20 min later you'll be done.
 

·
Registered
Joined
·
236 Posts
Discussion Starter #13
Ok I have the USB driver installed to my computer. When I plug the Smarty in with the USB cable the installer will pop up from windows like normal, i follow the steps but when I get to part where it is "search for the best driver in these locations" I am stuck. What do I type into the box?
 
1 - 13 of 13 Posts
Top