Dodge Cummins Diesel Forum banner

rotors

933 Views 5 Replies 3 Participants Last post by  Whitehouse23
Replacing rotors on my 98.5. When I removed the rotors the bearing came with it. I'm struggling with reinstalling. How do you get it lined up so when you tap it in place it goes. Any body have some advice or tricks to getting this thing back together?
1 - 6 of 6 Posts

· Registered
Joined
·
1,816 Posts
2 wheel drive or 4? Do you mean the bearing or the inner wheel seal?
 

· Registered
Joined
·
1,816 Posts
did you put the new inner seal and inner bearing into the new rotor, before you put it on.
 

· Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
I've since been told that the bearing should not have come apart. The hub and bearing assembly is supposed to be one piece and I probably need to replace them. That explains why putting it back together was so difficult.
 

· Registered
Joined
·
150 Posts
ive never heard of that happening, is that a common thing wit that happens when replacing the rotors?
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top