Dodge Cummins Diesel Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
193 Posts
Discussion Starter · #1 ·
im rebuilding my 12v and i was wondering what the crank and rod tolerances are + - they are all the same i used a mic on 3 points all the way around and they are in inches 3.26 and 2.71 in inch measurements and it looks like this motor has been gone thru before but the pistons are in poor shape it has standard bearings on both the rod and crank trying to order a rebuild kit tonight
 

·
Registered
Joined
·
462 Posts
Subscribed. Looking for the same information.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top