Cummins Diesel Forum banner

Replacing intake plate gasket. Need help

751 Views 4 Replies 5 Participants Last post by  strictlybiz
Blew out the gasket out of my intake plate. Never replaced one before and don't know where to start or any tricks to it. Any help is appreciated


Sent from AutoGuide.com Free App
1 - 1 of 5 Posts
Pulling injector lines isn't very hard at all. I would rather pull all the lines remove the plate right and make sure the surface is clean and that everything is lined up properly on the manifold again that trying to slide everything back under the lines and hop it lined up.

Mopar1973Man's Dodge Cummins Articles - High Pressure Injection Lines Removal
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top