Dodge Cummins Diesel Forum banner
1 - 1 of 1 Posts

· Banned
140 Posts
Discussion Starter · #1 · (Edited)
so I decided to tackle my rear drum brake job and leaking axle seals today. took pass. side brakes apart, removed diff cover (found its a full floating), so removed axle shaft. my question is do I have to start taking out the locknut, bearings, etc. to get to the seal? take the hub off? I don't want to mess with bearing preloads and all that if I don't have to.

thought this would be an easy job. confused now.

also, when replacing wheel cylinders, how do you keep all the brake fluid from leaking out of the line?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.