Dodge Cummins Diesel Forum banner
1 - 2 of 1 Posts

·
Registered
Joined
·
179 Posts
Discussion Starter · #1 ·
Hoping to get this fixed today so I don’t have to wait for Monday to contact Raceme.

Bought this secondhand and went through the process of making sure it’s up to date and it is version RAME011A which appears to be newer than any on the website. I get the errors below as I initially powered it on, but think it’s due to not having an open vin license. Anyways I go through and request a vin license and get it, shows up on the raceme monitor but when I press ECM programming it gives an error 12432 or “previous ecm programming was unsuccessful, we will recover the ecm with stock calibration. Gives the key on, key off loop and ends with an error of VIN locked.

I have a battery charger hooked up, checked the forums for answers but haven’t found a thread where the solution was actually posted. I’ll call raceme Monday if I can’t get it solved, but I have time today for the rest of the puzzle…

Any ideas?


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
179 Posts
Discussion Starter · #4 ·
Small update, didn’t make much headway over the weekend. Been going back and forth with tech support and it sounds like when the tuner was doing an ecm update on the previous truck that it was interrupted and now the controller is stuck in a key on key off loop. So, I just sent the controller back to get a new one…..


Sent from my iPhone using Tapatalk
 
1 - 2 of 1 Posts
Top