Cummins Diesel Forum banner

Please need help with leds

686 Views 6 Replies 2 Participants Last post by  Drc1340
I installed 3157 anzo led turn signals today on my 2011. I bought the 25w6.2ohm resistors from xdp. They won't flash when my lights are on. I tried the resistor on every wires possible and still no difference. They will flash with the lights off but as soon is I turn the running lights on they go solid. Anyone have any ideas? Possibly the wrong size resistor ? And the resistors get hot as they should. Thanks
1 - 2 of 7 Posts
Are you sure they didn't come on solid with the old bulbs? If you put on the turn signal do they flash like they should?
Have you tried it without the resistor at all? Iirc the worst that'll happen is it'll blink fast after 3 normal blinks
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.