[Drc1340]

I installed 3157 anzo led turn signals today on my 2011. I bought the 25w6.2ohm resistors from xdp. They won't flash when my lights are on. I tried the resistor on every wires possible and still no difference. They will flash with the lights off but as soon is I turn the running lights on they go solid. Anyone have any ideas? Possibly the wrong size resistor ? And the resistors get hot as they should. Thanks

 

[DMan1198]

Are you sure they didn't come on solid with the old bulbs? If you put on the turn signal do they flash like they should?

 

[Drc1340]

The old non led bulbs work fine. The led bulbs come on solid but won't flash. But if I turn the running lights off they will flash. Could the resistor need to be bigger than 25 watt?

 

[DMan1198]

Have you tried it without the resistor at all? Iirc the worst that'll happen is it'll blink fast after 3 normal blinks

 

[Drc1340]

Does the same thing with or without the resistor. will only blink with running lights off. But when I turn them in they won't blink they just stay solid

 

[Drc1340]

Does anyone think I should use a 50 watt resistor instead of the 25. Could that be my problem. Just hoping I didn't waste my money on these bulbs. Any help is appreciated

 

[Drc1340]

Anyone have more input? I ordered 50w 6ohm resistors today.