Dodge Cummins Diesel Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
861 Posts
Discussion Starter #1
Finally got the stack on guys let me know what u think of my design/fab work. instead of flex pipe i used sheet aluminum and hose clamps to sort of hold it like wrap clamp.. but im going to be putting in a piece of flexpipe instead of the elbow i think. :peelout
 

·
Registered
Joined
·
1,496 Posts
holy sh*t thats clean i like how you plated off the bottom of the stack where it connects to the bed
 

·
Registered
Joined
·
861 Posts
Discussion Starter #4
yea thats what i was going for and the stack was the perfect length. i didnt want it tall. with the plate what i did was just cut the plate out of 1/4 inch plate steel, than cut a 4 inch hole in the middle, welded in a 6 inch piece of 4" pipe, than welded the 5" stack to the other side. than cut a hole in the bed and bingo. i thought it was pretty ingenious and i like the clean look and ill get some pics up. i have a video but ill try and figure out how to get that up.. ill put it on you tube and get the link up.
 

·
It's got 12 Valves...
Joined
·
4,472 Posts
Nice videos :thumbsup. I am so jealous of the 12V smoke..I wish I had that :thud:
 

·
Registered
Joined
·
861 Posts
Discussion Starter #7

·
Registered
Joined
·
861 Posts
Discussion Starter #8
ha yea look at the video above...a little more smoke haha
 
1 - 8 of 8 Posts
Top