Dodge Cummins Diesel Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello. I am New on this forum, but my problem is that I installed turbo bleed valve on my 2001 dodge ram 2500 diesel and got turbocharger overboost condition (P0234). So I ordered Quadzilla boost fooler and plugged it after Diablo power puck and still my Ultragauge scan tool is telling me about overboost condition. I was wondering if it should be plugged straight to MAP or?
Another question is that ultragauge also reads 12.5 at idle and tops at about 22. I am assuming that the unit is PSI? Should it read 0 at idle? Also my Timbo APPS reads 12.5% at idle.
Replaced MAP sensor but it didn't affect anything.
Thank you for the answers!

-Sami
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top