Cummins Diesel Forum banner

NV5600 Reverse gear trouble

2K views 9 replies 9 participants last post by  side2000 
#1 ·
I have a 2004 Dodge 2500 6spd and every time i go for reverse it either slghtly grinds or dosnt go into gear. Please post any tips or suggestions.
 
#2 ·
souds like you need either new hydraulics or a new clutch, how does it do when the truck isnt running?
 
#3 ·
My dad's truck did the same thing. It's been a while since I drove it, but I think it was cured after a new clutch.
 
#4 ·
mine does the same thing, but if i hold the clutch for about 2-3 seconds and then go in to reverse it doesn't grind. It never grinds into a forward gear though. Does your act the same way?
 
#6 ·
mine will do it from time to time. . .I normaly clutch it to get the input gear set spinning then try again. . .goes into gear after that.
 
#10 ·
flick third then reverse. itll work for ya every time even w/ worn synchros.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top