Cummins Diesel Forum banner

NV4500 issues

626 Views 6 Replies 5 Participants Last post by  Fearthedeere076.7
Ok my put new master and slave clyinder in my truck. I can drive it now but it wont go into 1-3 i have to start in 4 and down shift to the gears. Once its in gear and drive it does ok except for 3rd grinds once in a while. and on occasion it doesnt want to go into 5th the first time i have to put it back in 4 and either clutchless shift to 5th or double clutch it. Any ideas where to start.
1 - 1 of 7 Posts
bad pilot bearing can also make it a pig to get through the gears
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.