Dodge Cummins Diesel Forum banner
1 - 1 of 11 Posts

· Registered
Joined
·
40 Posts
Priming a new engine can be really fun. With gassers you can sometimes access the oil pump with an electric drill and prime it without running the engine. Hmm on a gas vehicle you would remove the coil wire and crank it over to prime. Lastly I would take the oil pump off take it apart and pack it with bearing grease. It's alot of oil to kill, but it will be primed. The grease provides a nice air tight seal to allow a draw. Make sure there are no leaks anywhere air could get in. Good luck.
 
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top