Dodge Cummins Diesel Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
1,003 Posts
Discussion Starter · #1 ·
My 03 has the in tank lift pump conversion , and yesterday I drove it to a friends when I was leaving I truned the key to on the pump made noise but my gauge stayed at 0psi. I had to get the truck towed home I am dropping the tank now any thoughts?
 

· Registered
Joined
·
1,182 Posts
My 03 has the in tank lift pump conversion , and yesterday I drove it to a friends when I was leaving I truned the key to on the pump made noise but my gauge stayed at 0psi. I had to get the truck towed home I am dropping the tank now any thoughts?
Was it the noise it normally makes? I would check for in restriction in the fuel lines and tank.
 

· Registered
Joined
·
1,003 Posts
Discussion Starter · #3 ·
It sounds normal but no fuel flows
 

· Registered
Joined
·
1,182 Posts
Before you drop your tank I would take the supply line off the cp3 and see if fuel flows. It could be as simple as a bad gauge
 

· Registered
Joined
·
1,003 Posts
Discussion Starter · #5 ·
I pulled the line on the back of the fuel filter no fuel..
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top