[Rivey]

I have been running II 90s for a few months with a 66/74/14.
I cracked 2 a couple weeks ago and still have a good set of stock nozzles and the bad set of 90s . I figure it's time to go bigger anyway and can't decide where to send in the stock nozzles to get cut. Cp3 will eventually be someone's stage 3 so thats not a problem at the moment.
Goals are 700 rwhp with tnt/r only for tuning maybe SSR if I get ahold of one (No longer stacking a pressure box).
Need some input, I've asked several people I know and they all say 120's. For $300-330, These are the choices so far to get stock nozzles cut:

DDP's 120s
Extrude Hone's 60%
JL's EDM 120s
or ???

 

[Rivey]

Anyone have experience with Exergy?

 

[blackdieselram]

they are doing mine, i have heard nothing but good about them. i will let you know in a week or so :thumbsup:

 

[Rivey]

they are doing mine, i have heard nothing but good about them. i will let you know in a week or so :thumbsup:

do you know the turn around for them? complete injector or just nozzles? either way my truck will be down

 

[blackdieselram]

they said they try to have them done by 2 weeks.
i sent in my whole injectors and they are testing them and honing them. then they test them again to make sure they all flow within a certain percent of each other.

 

[JamesHunter]

What pressure box where you running?

 

[Rivey]

What pressure box where you running?

quad x2 race pressure only tune...supposed to max at 27.5k. Normally saw 26.xx WOT
It's for sale now.