Dodge Cummins Diesel Forum banner
1 - 5 of 5 Posts

· Premium Member
Joined
·
139 Posts
Discussion Starter · #1 ·
I bought https://www.headlightsdepot.com/2006-2008-dodge-ram-1500-2500-3500-headlight-left-driver-right-passenger-side.html these headlights. The Halo's and LED lights don't work. The rest of the lights work. The regular beam and high beam and turn signals work but the Halo rings and 4 LED lights at the bottom don't work. I wired them exactly as shown in the instructions. On the back of the headlight it came with a red and black wire to wire in to the turn signal for 2008 and a plug for 2006. If you undo the plug it has a black and red wire also. Should I combine those two red and black wires together and then connect them to the turn signal wires ? I will attatch the instructions. Please someone help me because HeadLights Depot is a foreign owned company and they are not very intelligent and customer support is not very good.
 

Attachments

· Registered
Joined
·
12 Posts
Have you been able to get the LEDs and Halo to turn on at all? You could just run wires straight to the battery to check them as a starting point. It's important to note that LEDs have to have correct polarity, meaning you can't mix up the positive and negative and have them still work like you can on a regular bulb.
 

· Premium Member
Joined
·
139 Posts
Discussion Starter · #3 ·
I checked the led by connecting them to the battery and they didn't light up. I just asked for a refund. Just waiting on RMA email .
 

· Rear Admiral Rickard Onmi
2018 Ram 3500 CCLBSRW
Joined
·
18,932 Posts
i've found, over the years, most of those style of housings tend to be lower quality with poor projectors. Your best bet for improving your lighting and looks is to do a retrofit yourself, like this

https://www.cumminsforum.com/forum/3rd-gen-non-powertrain/2480083-quad-retrofit.html

there are a lot of options when customizing housings, and you can make them entirely yours, while drastically improving looks and function.
 

· Premium Member
Joined
·
139 Posts
Discussion Starter · #5 ·
i've found, over the years, most of those style of housings tend to be lower quality with poor projectors. Your best bet for improving your lighting and looks is to do a retrofit yourself, like this

https://www.cumminsforum.com/forum/3rd-gen-non-powertrain/2480083-quad-retrofit.html

there are a lot of options when customizing housings, and you can make them entirely yours, while drastically improving looks and function.
I'm just going to order more expensive headlights and get the 1yr warrantyl .
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top