Dodge Cummins Diesel Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
92 Posts
Discussion Starter · #1 · (Edited)
I am converting to a single mass flywheel on an 06 six speed and need to know if the following is sufficient. I am towing a 11k fifth wheel durring summer maybe 12-15 times and no long pulls all under say 100 mile radius of home. I am going to add a towing chip and nothing else.


South Bend Dyna Max Upgrade Clutch Kit MU G56 Con O (Incl. Flywheel)
05.5-07 Dodge Cummins 5.9L with G56 Trans. 350 hp, 750 ft. lbs. torque
 

·
Registered
Joined
·
866 Posts
It will work but I think I would for one that can handle a little more hp. 350 is barely more than stock. Valair makes a single disc that will handle like 450 hp and its about $500.
 

·
Registered
Joined
·
145 Posts
I just installed the ofe in my 05. It just has the programmer on it. you will like this clutch. Not too grabby but still has firm engagement. I dont think you would be dissapointed
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top