Joined
·
1,718 Posts
is that the only code that it is throwing? If so remove your MAP sensor and clean it really good. Reinstall it and clear the codes again and give it a try.
Posts by Irish Maniac
-
March's Cummins of the Month challenge is now open for entries!
1 - 5 of 46 Posts
Joined
·
1,718 Posts
Also I am fairly certain that code can put you into limp mode..
Joined
·
1,718 Posts
Joined
·
1,718 Posts
probably the brake. Its fast drying and wont leave a residue. I used mild detergent w/water and a tooth brush and then just let it air dry good, hit it with some compressed air.
Joined
·
1,718 Posts
Its on the driver side of the engine on the intake horn. Will be just below your EGR plate kind of on the back side of the horn. Its held in by 1 #15 torx bit. And the connector that plugs into it is grey. I hope this helps.
1 - 5 of 46 Posts
