Cummins Diesel Forum banner

Need help installing TS Performance MPD

553 Views 0 Replies 1 Participant Last post by  C Cape
I'm installing it on my 06 and just want to make sure I'm getting the wires right on the sensors.

Crankshaft sensor - white wire connected to the wire towards the front of the truck (crank sensor is sideways with the wires in a line. I put it on the front wire) (I'm getting a screwy rpm reading so something isn't right here)

Fuel press - purple wire connected to the wire toward the driver side (reading over 1000 at idle

Map - connected to the middle wire on the sensor.

Please help me out guys. Thanks!
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.