Joined
·
178 Posts
how much psi will the factory map sensor read.
Map sensor reading
-
It's time to cast your vote for March's Cummins of the Month!
1 - 8 of 8 Posts
Joined
·
5,525 Posts
i believe its 44 psi.... then you will get and overboost code if your running a boost fooler....
Joined
·
178 Posts
Thats what i was afraid of. If this is true i assume the juice or pulse wont work to well for a twins setup putting out over 44psi. I wonder if anyone makes an aftermarket sensor for higher boost numbers
Joined
·
5,525 Posts
get a boost fooler, and plug it in, as well as leaving the edge plugged in, it should keep from from throwing a cel....
Joined
·
178 Posts
will the edge read the right pressure if i get a boost fooler
Joined
·
5,525 Posts
yes plug the edge into the map sensor, then plug the boost fooler into the edge harness, and the factory harness into the boost fooler harness...
Joined
·
178 Posts
Oh ok, so the map sensor will actually read more than 44 psi it is just at this point that it will throw a code? If this is correct how many pounds will the sensor read
Joined
·
5,525 Posts
not sure on the sensor, see what the edge will read, get a mechanical boost gauge for a true reading, thats my best suggestion for ya...
1 - 8 of 8 Posts
