Dodge Cummins Diesel Forum banner

Manual tranny, 2 piece rear driveshaft p/n's

504 Views 2 Replies 3 Participants Last post by  Sandaholic
I have an Nv5600 6 spd, 2 piece drive shaft and cant for the life of me find U-Joint part numbers of a place to get them. can anyone help me??? (I did find Auto Zone Duralast for 37 each but I dont know about autozones U Joints)
1 - 3 of 3 Posts

· Bangin' through the gears
Joined
·
5,521 Posts
I'm pretty sure they are 1480's. Use the search button and type in 1480. I have been running the non-greasable's as we all have stock. Went through and replaced all the rears once already (around 60,000 IIRC). Only one was shot, but I just replace them all. The greasables will last longer, but they are not as strong......pick your poison. I always get mine from Six States Distributor, alot of guys order from Rock Auto. Eventually I'm going to a single driveshaft. It'll be easier to make hoops for it.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top