February's Cummins Photo Challenge Is Now Open For Entries!

Looking for a measurement.

653 Views 4 Replies 2 Participants Last post by MEOB, May 20, 2008

MEOB

Discussion Starter · #1 · May 18, 2008

Just wondering what the hight of the rocker panel or bottom of the door is on a 3rd gen with a 6in lift and 37's? Ive been looking at pictures but its hard to judge.
thanks.

1 - 5 of 5 Posts

flynf7

· Registered

Joined Feb 24, 2007

·

82 Posts

#2 · May 19, 2008

mine has a 8" w/37's and only has a few inches to spare going in a 8' overhead door.
i can take a tape to it tomorrow for you

MEOB

· Registered

Joined Nov 29, 2006

·

104 Posts

Discussion Starter · #3 · May 19, 2008

Thanks that would be great.

flynf7

· Registered

Joined Feb 24, 2007

·

82 Posts

#4 · May 20, 2008

ground to the bottom of the pinch weld of the cab sides. 28"

ground to the middle of the drivers door handle 57.5"

hope it helps...

MEOB

· Registered

Joined Nov 29, 2006

·

104 Posts

Discussion Starter · #5 · May 20, 2008

Thanks thats great just what i was looking for.:thumbsup
Matt

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.