Dodge Cummins Diesel Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
44 Posts
Discussion Starter · #1 ·
Im looking at a KORE leveling kit for my truck and wonder if anyone has had a kit of theirs on there ride. They claim better than factory ride and the best leveling kit out for the price it looks tempting for $340 just not a spacer. So any info on KORE would be greatly appreciated.
 

· Registered
Joined
·
157 Posts
I just ordered one up this week. I'll be sure to post my thoughts once I get it installed.
 

· Registered
Joined
·
533 Posts
If you're going that direction, you should really think about doing the HP setup which will give you mini packs and Bilstiens in the back as well for about $600 I think.

I like my KORE system, granted it's not the same one, but in general, I think it's fair to say that KORE's systems are more precise feeling, eliminate body roll, etc. Some think the ride is too stiff, but it's still a light year improvement over the factory setup. Let's face it, $600 for a four corner system and bilsteins is pretty darn good.
 

· Skrew- EPA CARB OPEC PETA
Joined
·
1,563 Posts
KORE has top-of-the line components and is well worth the money! My buddy has the HP setup and it has vastly improved his ride.
 

· Registered
Joined
·
44 Posts
Discussion Starter · #7 ·
thanks guys i just couldnt pass up the level kit for that price...i can always add the rear stuff later (wife started adding up the goodies ive put on my truck so this may be it for awhile). Also looking forward hearing from yall about the hp kit. Only thing is i gotta wait till mid june to get it, wont ship till the 3rd so till then:popcorn: Info much appreciated!!
 

· Registered
Joined
·
240 Posts
I plan on using KORE when I lift my truck. They are a proven company. Any company who can drive their truck from the shop in Cali down to Mexico, race the baja 1000 and drive back gets two thumbs up in my book.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top