Cummins Diesel Forum banner

Keyless entry door pad?

7668 Views 12 Replies 4 Participants Last post by  DodgeLuvr
Hey guys, Ive got an 04 that I want to add a keyless entry pad on the drivers door like the fords have. I am looking for an aftermarket kit that I could add without doing alot of modifying.
I saw a kit one time that had a wireless pad that attached to the door with 3m tape and then a module that wired in under the dash, this is exactly what I'm lookin for. Does anyone know where to find one??
I know bulldog used to make one but im not sure about how the quality would be, there are some negative reviews about it on amazon and it seems to be a discontinued product from bulldog.
Heres a link. Bulldog TP-100 Touch Pad Keyless Entry System: Automotive

I also found this kit, it looks really good but it has to drill through the door panel. The wiring harness also has to pass through the door jamb, I think it would eventually end up causing problems there, with pinched wires ect.
Keypad Keyless Entry: A1 Electric Online Store
Automotive keypad keyless entry system

Has anyone else installed something like this, or know of any other manufactures that make something like this??
Thanks Alot.
1 - 5 of 13 Posts
as for wire through the door jamb, thats how speaker wires and electric window controlls get their power and such route it the same way and they wont pinch
true, but I dont think you can run your wires in the factory boot because of the harness plug and such, I could be wrong but I think you'd hafta run your own boot and gromits.
It is Possible, but its hard to beat wireless.
The factory keychain with the door locks on it works for years on the original batery so I dont think that should be an issue.
Had this on my 89' and loved it, never get locked out again.

Axess Keyless Entry System
This kit looks great! was the one you had wired or wireless?? I see they offer both. The keypad styling isnt that attractive, but im mostly going for function anyway.
well till they figure out how to pass concitrated electrons thru thin air, i dont know how else they are gonna do it.:lol4:
Ive seen a few vehicles with these modular door contacts. they eliminate the wires through the jamb. since i'll only be using the kep pad with the door shut I think this is the way to go.
The Hoffman Group - Keep It Clean - Modular Door Contacts

These look good too. if you had to run wires to the door this would be a nice way to do it.
The Hoffman Group - Keep It Clean - Door Looms - Billet Door Looms, Rubber Door Looms
Ultra Touch - Ultra Touch Invisible Switch[/QUOTE]

Thats Trick!! ive never seen that before. behind the mirror or on the window behind the drivers door would be sweet!!:thumbsup:
1 - 5 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.