So i finally completed my gauge install and wanted to see if these numbers are normal.
at idle FP is 11psi.
30mph FP is 10psi, EGT 400
"WOT" FP goes down to 5psi and holds there, EGT 800, boost 21-22psi.
I'm thinking FP is too low, i believe it should hold at 10-15psi regardless of driving condition correct?
also for the boost, I'm not sure if its correct, i remember reading that it should be 30-35psi stock but reading the manual it says that boost during testing should be about 18 give or take 1.5 and WG opens at 19.
my boost reference is coming from the 3/4" port just before the MAP sensor.
i should also mention that i have an Edge tuner going in but not installed yet HOWEVER i did install the boost elbow on the compressor housing. not sure if that would affect any of these numbers.
thank you
at idle FP is 11psi.
30mph FP is 10psi, EGT 400
"WOT" FP goes down to 5psi and holds there, EGT 800, boost 21-22psi.
I'm thinking FP is too low, i believe it should hold at 10-15psi regardless of driving condition correct?
also for the boost, I'm not sure if its correct, i remember reading that it should be 30-35psi stock but reading the manual it says that boost during testing should be about 18 give or take 1.5 and WG opens at 19.
my boost reference is coming from the 3/4" port just before the MAP sensor.
i should also mention that i have an Edge tuner going in but not installed yet HOWEVER i did install the boost elbow on the compressor housing. not sure if that would affect any of these numbers.
thank you
