[yamahajo]

Just got it all working and its reading 13psi at idle and under a load it gets down to 7psi. I dont run my trucks wide open, so idk what it is a full throttle... I called Genos to get price a new lift pump and the fella there said that there was no need for a new pump. He said as long as it doesnt get below 5 psi im golden, But on here everyone is saying 10-20. My truck is completely stock so will these current pressures work? I dont want to burn the VP up soo i want to make sure before i drive it too much.
Thanks!!

 

[yamahajo]

thats what im guessing...looks like its time to get a new LP!

 

[yamahajo]

any pump recomendations? Frame mounted or block mounted?
Thanks!

 

[yamahajo]

I think im going with the raptor, but naturally i have a few questions. I have an 01 with the block mounted LP. When i buy the raptor, will i need to run a new line from the tank to the raptor, then from the raptor to the stock LP filter then to the VP44? Or can i just mount the raptor on the frame and use the old hard lines to tie into the raptor, then from the outlet of the raptor run 1/2 to the stock LP then Vp44? And do i need a drawstraw? I really dont want to have to pull the bed off and mess with the tank if i dont have too....
thanks!!!

 

[yamahajo]

i got the whole raptor 150 kit. Very nice setup, easy to install and works like a champ soo far. Little trouble getting the psi right, but its ideling 19ish now, so its good enough for me.
Thanks!!!