Cummins Diesel Forum banner

how to code free and flicker free HID lights

3481 Views 7 Replies 4 Participants Last post by  BigRedRam95
here is for everyone that can crimp or better solder few wires together, how to make your own harness for Flicker Free HID lights
get 4 yes (four) 50w 6 ohm resistors , ebay is the cheapest. or wherever u want to get them...
and if you can-- follow the schematic below.
make sure you bolt the resistors to the metal chassis not plastic parts or you going to have problem!!!!! it will melt or catch fire in the worst case...its as hot as your 50w light bulb....

worked for mine will work for yours.
good luck

See less See more
  • Like
Reactions: 1
1 - 2 of 8 Posts
so if i only have the low beam kit i am assuming i only need 2 resistors?
if there is a decently priced harness for just the low kit i would rather do that. i am mechanicaly inclined enough to wire in capacitors but a plug in kit is much simpler
1 - 2 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.