Dodge Cummins Diesel Forum banner

how to build a streetable puller?

935 Views 6 Replies 3 Participants Last post by  jimbob5.924v
im getting a 95 reg. cab dually. it has a full billit redline auto. the kid dropped a p-pumped 24v in it. could you guys give me a good list to go by for the build? im getting 12mm studs and 250 sticks tomorrow. i was thinking of going with a twin kit. its also suppose to have titanum u-joints too.
1 - 7 of 7 Posts

· If you aint 1st..Ure LAST
Joined
·
2,276 Posts
go with twins. be alot more streetable.
 

· If you aint 1st..Ure LAST
Joined
·
2,276 Posts
that is my plan.i found some on here. what kind of hp can i make with a 35 to a ht3b?
with 250's? ummm id say well over 500hp. i'm sure. maybe even 600hp. just according to wat you have your pump set on. just a guess.
 

· Registered
Joined
·
172 Posts
Discussion Starter · #7 ·
im limited how how much allowance my wife gives me but i was thinking of swaping to a 215 pump. i just have to get the twins which i might get this weekend and i have to get my head done. the tranny is suppose to hold 1000hp but i want to get to about 800hp if i could
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top