Dodge Cummins Diesel Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
340 Posts
Discussion Starter #1
ya i know this question goes up a lot but i'm just curious. i had my truck dynoed and it went like 380 something so i rounded up to 400 in my sig. because they didn't turn my backdown off on my chip! that was before a put the cold air intake and arc flow manifold and some little stuff like that. but looking at my sig what would you think i should be hitting?
thanks
 

·
Registered
Joined
·
4,118 Posts
around 400-450 i think.
 

·
Registered
Joined
·
643 Posts
You should be a little more then that I would think. I did 450 with Edge 80hp injectors with the items in my sig. but all dynos are different. Alot depends on the operator of the dyno, how its set up, the altitude and weather and alot of other things.
 

·
Registered
Joined
·
340 Posts
Discussion Starter #4
sweet thanks for the input! i was really dissapointed to only hit what i did after putting 5 grand into the truck! the shop that i had do it only really know bully dog chips so i don't think they could turn off the back down or anything! heck they didn't tap the fuel pump with my chip after i lost the old vp 44 i had to like show them what to do! if i'm above 400 then i'm happy !!
 

·
Mark Ward
Joined
·
837 Posts
around 450 sounds about right. I dynoed 495 with a Silver 62, 150's and Edge
 

·
Registered
Joined
·
2,692 Posts
I would be happy to see 500hp on my truck
 
1 - 6 of 6 Posts
Top