Dodge Cummins Diesel Forum banner

Grease sealed ball joints?

2281 Views 3 Replies 3 Participants Last post by  TedT
Is it ok to use a needle to grease under the seal of sealed ball joints. Or does that do more harm than good?
1 - 4 of 4 Posts

· Registered
Joined
·
469 Posts
I've never tried it, but a while back there was someone else on here that said that they did it at every oil change and had lots of miles, I can't remember how many, without any problems. I would think it's a good idea, will probably start doing mine soon. Don't forget about the front drive shaft.
 

· Registered
Joined
·
2,297 Posts
Discussion Starter · #3 ·
Definitely.

I got the tie rod ends and dshaft point last weekend. That one was a little tough to tell when it had enough grease in it. I was able to get the needle in the edge of the fitting and get some in.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top