Dodge Cummins Diesel Forum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
4,062 Posts
Discussion Starter · #1 ·
So I took my truck down to Bismarck and I wanted to get some baseline numbers... but Im kinda wondering about the way they did it. The dyno was a Mustang dyno. But when they did the run they never hooked up anything he just had my friend stick in 2nd and giver hell. I thought in other runs I've seen they hook up a wire to the motor for a tach signal, but he never did that, so would my numbers be slightly off? Good or bad? Thoughts?

My mods are....
AFE Stage II
4 in. Straight pipe
Edge programmer
4.56 gears

I just wanted some numbers before i start approaching more power mods.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top