Cummins Diesel Forum banner
Cancel

Gauges installed, trans temp not working?

637 Views 3 Replies 3 Participants Last post by  mathewshunter, 
mathewshunter
I got my 3 isspro's in yesterday. EV1 boost,pyro,trans temp on the pillar. I drove it about 25mi last night and my tranny temp doesn't seem to be working. It's installed in the rear test port using the sender extender. Anything specific that may be causing it? Or is the temp not getting hot enough yet? The gauge stats at 100 and was about 40 degrees outside last night. I'm going to check all wires for power and i had to cut the sender wiring to extend it to reach the tranny so I'll check all that, but I'm pretty sure i got power to everything. It's pouring rain today so it may be a few days before I get to check it.
Reply
Save
Like
1 - 1 of 4 Posts
icon420
my transmission gauge hits 100 - 140 at most thats workin er pretty hard.....try putting it in neutral and using your high idle @ 1500rpm for a while that should do er. for the most part mine doesnt move much either
Reply
Save
Like
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cummins Diesel Forum
A forum community dedicated to all things Cummins Diesel! Originally founded for owners and enthusiasts of Cummins powered Dodge pickups, the Cummins Forum has expanded to include ALL Cummins Engine applications! Come join the discussion about reviews, drivetrain swaps, turbos, modifications, classifieds, builds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
03-07 Performance Parts Discussion 03-07 Powertrain 2013-2018 General Discussion 98.5-02 Powertrain 98.5-02 Performance Parts Discussion
Top