Cummins Diesel Forum banner

Gauges installed, trans temp not working?

637 Views 3 Replies 3 Participants Last post by  mathewshunter
I got my 3 isspro's in yesterday. EV1 boost,pyro,trans temp on the pillar. I drove it about 25mi last night and my tranny temp doesn't seem to be working. It's installed in the rear test port using the sender extender. Anything specific that may be causing it? Or is the temp not getting hot enough yet? The gauge stats at 100 and was about 40 degrees outside last night. I'm going to check all wires for power and i had to cut the sender wiring to extend it to reach the tranny so I'll check all that, but I'm pretty sure i got power to everything. It's pouring rain today so it may be a few days before I get to check it.
1 - 1 of 4 Posts
Go for a drive in tow/haul mode up a couple hills. If the gauge isn't working still, then check your ground wire. I have read that the test port isn't a good place to get the readings from.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top