Cummins Diesel Forum banner

FP Gauge on Airdog?

914 Views 6 Replies 5 Participants Last post by  DodgeMech
I tried searching but apparently something is wrong with it?? Anyways I was wondering if there was anything wrong with using the port on my Airdog 100 to hook up a fuel pressure gauge? I like this idea better than splicing the fuel line to insert fittings into, and getting a tapped banjo bolt seems kinda silly where I've got high flow fittings only to get something restrictive right before the fuel enters the IP. Your thoughts?
1 - 1 of 7 Posts
push lock

screw the screw end into the VP, put the fuel line on the end, screw your Napa WH-6820 needle valve into the hole, and then screw your electric sender into that
See less See more
  • Like
Reactions: 2
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.