Dodge Cummins Diesel Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 5 of 5 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
My '94 has this stamped engine cover similar to a valve cover. I'm going to make a billet aluminum cover and would like to know what other years are these covers found on? I do CNC work like this (pics for views):




Mine just has two studs that are fixed into the motor that it mounts to. Doesn't seal anything, just a beauty piece.

:beer,
Ryan
 

·
SC Chapter President
Joined
·
1,024 Posts
I think all 12 valves have them, I'd be interested in one depending on what you make, I'd also be interested in talkin' to you about some custom CNC work if you'd be interested.
 

·
Registered
Joined
·
14 Posts
Discussion Starter #5
I'll post up some pics when I get it done. Probably be a few weeks before I can get to it. I'll need to make a fixture, but that shouldn't be too big a deal.
 
1 - 5 of 5 Posts
Top