Dodge Cummins Diesel Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
So i have the dash apart in my 90 2500.

fixing the heater, installing a stereo and replacing burnt dash lights.

after its all fixed up I check the gauge lights, they all work. but after a few seconds i see smoke from the light control switch?

its the illumination wire and its now melted. lame. I cut the wire, turn on the switch again no smoke.

so was there too much of a draw? or did something short out?:S:
 

· Registered
Joined
·
20 Posts
Discussion Starter · #4 ·
ahh man, do I ffel stoopid:banghead:

I had my car hauler trailer attached, and one of the straps wore through a driving light wire. unplugged the trailer, problem solved:rof

next problem......anyone know anything about the wiper motors?

thanks Dan
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top