Dodge Cummins Diesel Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
742 Posts
Discussion Starter · #1 ·
So I was messing around with my laptop and mystyle software but I couldn't get it to connect to the monitor. I left it plugged in in my truck with the key off and it couldn't read it. Does the truck need to be running or on or do I need to completely disconnect it?
I did turn my truck on so it would power on, then connected the cable which made it connect and read on my laptop.. but then the monitor itself froze. So I had to unplug the obdII to reset it.

Do I need to do anything special here and does mystyle actually update the monitor or is it just a customized tool thru my computer?

I'll also be installing a fuel sensor through the eas system this week. Anything needed there or will it just plug in and read? I have all of the wiring necessary.

Thanks
 

·
Registered
Joined
·
742 Posts
Discussion Starter · #4 ·
Its kind of a to get it out of the pod so I could just unplug the obdII correct? Only other thing connected to it is the eas and egt probe.
 

·
Registered
Joined
·
742 Posts
Discussion Starter · #6 ·
Thanks man. It all worked this time around.
 
1 - 3 of 3 Posts
Top