Dodge Cummins Diesel Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter #1
I am trying to install the edge juice with attitude and my map sensor isnt lining up..the sensor that they sent me for it is the same exact sensor that the mass air flow sensor is..did they send me the wrong plug? that is the only thing i can think of..thanks in advance
 

·
Washington Chapter Vice President
Joined
·
5,059 Posts
who sent you a plug? Is it part of the edge? The map sensor should have 4 wires in it.
 

·
Premium Member
Joined
·
1,185 Posts
I just got off the phone with him. He called me last night asking about the plug after he posted this. He couldn't find the Map sensor. He was looking at the 2 plug between the 2 injector plugs. He found the right spot and just said everything is working fine and loves the power.
 

·
Registered
Joined
·
69 Posts
Discussion Starter #4
yeah i finally got everything lined up right..the directions said it was on top of the motor between the two injector clips..the directions or a little misleading but i found it..thanks
 

·
Washington Chapter Vice President
Joined
·
5,059 Posts
good to hear you got it fixed up.
 
1 - 6 of 6 Posts
Top