[Michael]

I didn't realize that the 6.7L added a factory drive pressure sensor. I'll have to add a reference in the instructions for the ISSPRO Exhaust Backpressure Gauge.

Regards,
Michael Pliska

 

[Michael]

Most ISSPRO dealers should have what you need. Here is a list of forum sponsors that are ISSPRO dealers:
FTE Diesel - Jackthebear3
Holland Court - jbarker
Genos Garage - Genos Garage
Rollin Smoke Diesel - Rollin Smoke Diesel
Xtreme Diesel Performance - [email protected]
8LugTruckGear.com - Skyd Ram George
dieselautopower.com - jkidd

We are releasing an installation kit to go with the Exhaust Backpressure (i.e., drive pressure) gauges. It will come with a pre-coiled length of tubing and necessary fittings for installation directly into an exhaust manifold. If tapping into the 6.7L's factory sensor plumbing you would need to add a tee and a few more fittings. I'll look into releasing a 6.7L kit too!

Regards,
Michael Pliska

 

[Michael]

Would it be possible to create an interface to utilize the factory drive pressure sensor to run an aftermarket gauge? Similar to the way the rail pressure gauges work now. IMO that would be the best setup.

Good point. I'll look into it.

 

[Michael]

BTW - the install kit has been released, R78855. List price (of course nobody actually pays list price with the internet around) is $24.89.

Regards,
Michael Pliska

 

[Michael]

Sorry, this kit is so new it won't be on anyone's website yet (including ours)! You can have your dealer order it through us though with that part number. The kit includes 27" of 3/16" annealed copper tubing pre-coiled, with compression fittings and 1/8" NPT male and female connections.